xPico^® Wi-Fi^® SMT (u.FL connector version)  

Wireless LAN Interface

• IEEE 802.11 b/g and IEEE 802.11n (single stream) WLAN interface (2.4 GHz only)
• IEEE 802.11 d/h/i/j/k/w/r
• u.FL connector for external antenna

Serial Interface

• Two Serial CMOS Ports (3.3V, 5V tolerant)
• 300 to 921.6 Kbps
• Flow control XON/XOFF, RTS/CTS (SPort 1 only)
• Lantronix tunneling application

Host Interface

• Dual Serial Port, SPI, USB 2.0* (device)
• 8 GPIO

Network Protocols

• TCP/IP, UDP/IP, DHCP, ARP, ICMP, DHCP, Auto-IP, DNS, SNMPv1

Networking Capabilities

• Soft Access Point with DHCP Server
• Lantronix SmartRoam Technology* continually tracks Wi-Fi signal strength within range, along with preauthentication and caching resulting in smooth and automatic transition to access points without delay.
• QuickConnect: Dynamic Profiles facilitate easy and rapid connections to access points

Management and Control

• Web Server – Landing Page
• CLI (Serial Monitor Port)
• XML import and Export (XCR)
• Field upgradable firmware (OTA)

Security

• IEEE 802.11i Support – WPA-Personal, WPA2-Personal
• 256-bit AES Encryption*

Architecture

• ARM Cortex M3 class processor with on-chip Flash and SRAM
• 1MB Flash and 128 KB SRAM
• 1MB SPI Flash storage

Power

• Input Voltage: 3.3VDC
• Low power consumption of approximately 6μA standby

Physical Interface

• 40-pin Board-to-Board SMT Connector

Environmental

• Operating Temp: -40° to +85° C
• For operation over +70° C a thermal pad is required
• Storage Temp: -40° to +85° C
• Relative Humidity: 0% to 90% non-condensing

Certifications

• FCC Class B, UL and EN EMC, Japan

Packaging

• Dimensions: 24mm (L) x 16.5mm (W) x 5.64mm (H)
• Weight: 2.5g

Warranty

5-Year Limited